Brand: Seachem
Product Code: F5.2000
Availability: Available
57.00 €
Ex Tax: 47.50 €
Have questions?
  • Email

    yes@iamreefer.com

  • Phone

    +372 880 45 15
    Mon - Fri: 10:00 - 18:00

  • Contact form
Seachem PhosGuard 2000ml rapidly removes phosphate and silicate from marine and freshwater aquaria
PhosGuard™ rapidly removes phosphate and silicate from marine and freshwater aquaria. Although PhosGuard™ is effective in both fresh and marine water, it will operate better in sea water and the need for it is better defined in sea water. It is not recommended for phosphate buffered freshwater (PhosGuard™ would remove the buffer until saturated). PhosGuard™ is highly porous and bead-shaped to promote easy water flow through and around it, thereby increasing both its efficiency and capacity.

May generate heat on initial contact with water. Pre-wet by adding to a double volume of freshwater, followed by a rinse. For best results, PhosGuard™ should be rinsed before use and placed so as to maximize the flow of water through it but not so that it tumbles against itself in flow. It may be used in a canister filter, media chamber, box filter, or any high flow area of a trickle filter. Use of a filter bag is recommended. Use 85 mL (1/3 cup) for every 200 L (50 US gallons) saltwater or 400 L (100 US gallons) freshwater.

Leave product in place for 4 days, then test phosphate or silicate concentrations with either MultiTest™ Phosphate or MultiTest™ Silicate. If the concentration of the component you are trying to decrease has not dropped to around 0.02 mg/L, then replace the PhosGuard™, otherwise leave in place until levels begin to climb again. As long as concentrations remain under control, the product is not exhausted. Over treating is not recommended. PhosGuard™ is not an exchange resin and does not release anything into the water. It does not leach phosphate or silicate back into the water and may be removed, dried, and returned to service until exhausted. Continuous use of small quantities is better than intermittent use of larger quantities.

Comparing Seachem Phosphate Removers
Product PO4 bound
PhosGuard (Alumina Oxide) 0.87 mg/g
PhosBond (GFO and Alumina Oxide hybrid) 1.19 mg/g
PhosNet (GFO) 1.41 mg/g

CAUTION: When wetting the product for the first time, it should be made wet with twice its volume of freshwater by adding the product to the water. Avoid adding water to the product. Avoid using marine water for the initial wetting. Adding marine water to the dry product may generate sufficient heat to boil the water. Freshwater generates much less heat and adding the product to the water allows the heat to dissipate safely.

Package : 2000 ml 

Write a review

Note: HTML is not translated!